If the Status LED is green, go to step 7. Firmly close the roll compartment cover, so the top cover entirely closes on the left and right corners.
Thread it out the label output slot until the end comes out of the slot. Thread the roll through the label printer and under the sensor. Install the roll into the roll spool guides.į. Lift the roll compartment cover to open it.Į. Pull the release levers on both sides of the label printer to unlock the roll compartment cover. If the Editor Lite LED is on the label printer, hold down the Editor Lite button to turn off the LED.ī. Disconnect the USB cable from the label printer.ģ. If the Status LED is now green, try printing again.Ģ. Clear the error on the computer or mobile device.Ĭ. Check for an error message on the device you are printing from.ī. The control panel of your label printer may differ slightly from the images below.ġ. the media size selected in the application is not the size installed in the label printer the top cover is open when attempting to print an incompatible label roll is installed (red/black labels are not compatible with this model) The Status LED flashing red can be caused by a few issues :
0 kommentar(er)
